19.6. Labeling Disk Devices

During system initialization, the FreeBSD kernel will create device nodes as devices are found. This method of probing for devices raises some issues, for instance what if a new disk device is added via USB? It is very likely that a flash device may be handed the device name of da0 and the original da0 shifted to da1. This will cause issues mounting file systems if they are listed in /etc/fstab, effectively, this may also prevent the system from booting.

One solution to this issue is to chain the SCSI devices in order so a new device added to the SCSI card will be issued unused device numbers. But what about USB devices which may replace the primary SCSI disk? This happens because USB devices are usually probed before the SCSI card. One solution is to only insert these devices after the system has been booted. Another method could be to use only a single ATA drive and never list the SCSI devices in /etc/fstab.

A better solution is available. By using the glabel utility, an administrator or user may label their disk devices and use these labels in /etc/fstab. Because glabel stores the label in the last sector of a given provider, the label will remain persistent across reboots. By using this label as a device, the file system may always be mounted regardless of what device node it is accessed through.

Notatka: This goes without saying that a label be permanent. The glabel utility may be used to create both a transient and permanent label. Only the permanent label will remain consistent across reboots. See the glabel(8) manual page for more information on the differences between labels.

19.6.1. Label Types and Examples

There are two types of labels, a generic label and a file system label. The difference between the labels is the auto detection associated with permanent labels, and the fact that this type of label will be persistent across reboots. These labels are given a special directory in /dev, which will be named based on their file system type. For example, UFS2 file system labels will be created in the /dev/ufs2 directory.

A generic label will go away with the next reboot. These labels will be created in the /dev/label directory and are perfect for experimentation.

Permanent labels may be placed on the file system using the tunefs or newfs utilities. To create a permanent label for a UFS2 file system without destroying any data, issue the following commands:

# tunefs -L home /dev/da3

OstrzeżenieIf the file system is full, this may cause data corruption; however, if the file system is full then the main goal should be removing stale files and not adding labels.

A label should now exist in /dev/ufs2 which may be added to /etc/fstab:

/dev/ufs2/home     /home            ufs     rw              2      2

Notatka: The file system must not be mounted while attempting to run tunefs.

Now the file system may be mounted like normal:

# mount /home

The following command can be used to destroy the label:

# glabel destroy home

From this point on, so long as the geom_label.ko kernel module is loaded at boot with /boot/loader.conf or the GEOM_LABEL kernel option is present, the device node may change without any ill effect on the system.

File systems may also be created with a default label by using the -L flag with newfs. See the newfs(8) manual page for more information.

Ten i inne dokumenty można pobrać z ftp://ftp.FreeBSD.org/pub/FreeBSD/doc/.

W przypadku pytań o FreeBSD prosimy przeczytać dostępną dokumentację przed kontaktem z <questions@FreeBSD.org>.
W sprawie zapytań o tę dokumentację prosimy o kontakt z <doc@FreeBSD.org>.